PegasusAstro Motor Focus Kit v2 Celestron SCT/EdgeHD 6", 8", 9.25", RASA 8"

This geared stepper motor has steps of 0.0625°, a torque of 60 Ncm and low backlash, so you can use it to focus your telescope quickly and accurately - even with heavy camera systems.
 
Useful resolution of 0.0625° (3.75 arc minutes) per step
High torque to handle higher loads
Low backlash, which makes gear backlash compensation easier
RJ45 socket allows the use of standard network cables to connect to PegasusAstros Dual Motor Focus Controller
Specially shaped bracket allows mechanical connection with Celestron SCTs of 6", 8" or 9.25" opening as well as with RASA 8"
The holder comes in a black design, although the last picture shows it in a light blue color.

Focus your Celestron SC telescope precisely and quickly with the powerful motor focus kit v2 from PegasusAstro. This high-resolution gear unit has a step width of 0.06 degrees and can easily lift more than 6kg (with a lever of 1cm). The high torque is suitable for lifting heavy imaging equipment. In addition, the motor gear has a small backlash, which can be easily adjusted through backlash compensation in the imaging software.

The pulley and belt design allows the motor to keep some distance from (and not collide with) your filter wheel when using a Focal Reducer. The sophisticated bracket design fits most Celestron SCTs.

Note: You also need a stepper motor controller to drive the motor. Consider the Dual Motor Focus Controller linked in the Recommended Accessories section.

Bracket and pulley
A specially shaped black anodized aluminum bracket that is difficult to bend can be attached to most Celestron SC telescopes. There are three kits with two different pulleys. The manufacturer has successfully fitted these kits to:
Celestron Classic & EdgeHD 6, 8, 9.25 (SKU:PEG-MFKv2-SCT68925)
Celestron Classic & Edge HD 11 (SKU:PEG-MFKv2-SCT11)
Celestron Classic & Edge HD 14 (SKU:PEG-MFKv2-SCT14)
Celestron RASA 8 (SKU: PEG-MFKv2-SCT68925)
Celestron RASA 11 (V2 - for V1 you need the Celestron retrofit kit) (SKU:PEG-MFKv2-SCT11)
Celestron RASA 14 (SKU:PEG-MFKv2-SCT14)

Installation instructions in English
The manufacturer provides English instructions as a PDF, which can be downloaded here.
Motor step angle: 7.5°
Gear ratio: 1/120
Gear step angle: 0.0625°
Steps per revolution: 5760
Reversal backlash: approx. 30 steps (half-step drive)
Motor shaft diameter: 5 mm
PPS: 400
Torque (N⋅cm): 60 (100pps)
Phases: 4 (unipolar motor)
Voltage: 12V DC
Current (A): 0.27
Electrical connector: RJ45
Total weight (motor unit, SCT adapter, motor pulley, belt): 300 g
High-resolution stepper motor gear unit (step angle 7.5 degrees, ratio 1:120)
Black anodized aluminum mount for Celestron SCT telescopes
timing belt
Pulley, bore size 13mm
Bolt